Primera-technology AP362 Uživatelský manuál

Quick Start© 2009 All rights reservedUnpacking and Setup 3Loading the Label Stock 4Loading the Container 9Applying the Label 12Label Path Diagram 1

10 AP360/362 Label Applicator 3. Place the container on the Container Idler Roller and Container Drive Roller. Orient the container with the top to

AP360/362 Label Applicator 11Important Note: For bottles with a neck such soda, beer or wine bottles only one Container Guide can be used. Move the

12 AP360/362 Label Applicator A. Apply the Label1. Power on the Label Applicator using the Power Switch. This can be done at any point with orwitho

AP360/362 Label Applicator 134. Press the Foot Switch to apply the labels. Both labels will be applied without pressing the Foot Switch again.To se

E. Change the Unit of Measure between Metric and English.The AP362 can display measurements in both centimeters and inches. Follow these steps toswi

AP360/362 Label Applicator 15Section 5: Label Path DiagramLabel Path Container Drive Roller Container Idler RollerPeel EdgeLiner Drive RollerLiner Id

TroubleshootingLabels are applied to the container crooked.1. Check for container taper. Some containers such as wine bottles may have a slight tapert

MaintenanceLabel edges fold over or catch on the sensor as they are applied to the container.1. Over time adhesive from the labels can build up on th

Container width: 1.0" to 9.4" (25.4mm to 238.8mm)Container diameter: 0.6" to 6.7" (15.2mm to 170.2mm)Container shape: Cylindrical

AP360/362 Label Applicator 19

Notices: The information in this document is subject to change without notice. NO WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERIAL, INCLUDING

P/N 511218 - 101609

Thank you for purchasing the AP360 or AP362 Label Applicator (hereafter referred to as "LabelApplicator"). Bottles, cans etc. will collecti

1. Remove the Roll Bar and Roll Guides from the Label Applicator. The Roll Guides and RollDrag Arm are removable and adjustable. They are held in pl

4. Place the Roll Drag Arm under the Roll Bar. The Roll Drag Arm may be placed on either sideof the Roll Bar but the rounded tip of the Roll Drag A

6. Now position the stock to correspond with the general area where it will be applied to the container.7. Pull the loose end of the label stock forwa

9. Take the loose label stock and feed it between the Liner Idler Roller and the Liner Drive Roller. (Figure 2-7.) In order to feed the label stock b

11. If necessary, adjust the position of the liner on the Peel Edge left/right to align the liner withthe label stock roll. Also, adjust the Label Sen

AP360/362 Label Applicator 9The AP360/362 can apply labels to a variety of containers including wine bottles, soda bottles,jars, cans, etc. Dependin